NFPA 70E 110.4(B) / 120.1
What it means on the job
Damaged test lead insulation can expose the user to electrical shock and can cause phase-to-phase or phase-to-ground short circuits resulting in arc flash. All test equipment must be inspected before each use per NFPA 70E and replaced if damaged.
Tested in 1 CraftIQ puzzle
- whats-wrongUnion Hall Training: Motor Control Center Troubleshooting
Related NFPA sections
NFPA 652 / ACGIH Industrial Ventilation Manual Chapter 7
The exhaust fan must be located downstream of the dust collector (clean-air side) to prevent abrasive particulate from eroding fan blades and housing. Fan erosion causes imbalance, vibration, premature failure, and potential spark generation in explosive dust environments. NFPA 652 and ACGIH guidelines require clean-air-side fan placement.
NFPA 652 / NFPA 69 / OSHA 1910.22
Ductwork carrying combustible dust to a collector must have spark detection and/or suppression systems to intercept incendiary sparks before they reach the collector. NFPA 652 (Standard on the Fundamentals of Combustible Dust) and NFPA 69 require spark mitigation for processes that generate sparks, such as grinding, cutting, or welding operations.
NFPA 68 / NFPA 484 / OSHA 1910.94
Aluminum dust is highly combustible and explosive. Dust collectors handling combustible metals must have explosion relief vents sized per NFPA 68 to safely relieve deflagration pressure. Without relief venting, an internal dust explosion can rupture the collector, sending shrapnel and flame into the facility.
NFPA 70E 130.7(C)(10)
A standard face shield does not provide arc-rated protection for the face and neck. Category 3 requires an arc-rated balaclava worn under an arc-rated face shield and hard hat to protect exposed skin from arc flash burns.
NFPA 70E 130.7(C)(7) / Table 130.7(C)(7)(a)
When performing energized electrical work such as voltage testing on a 480V MCC, voltage-rated insulating gloves with leather protectors are required. Class 00 or Class 0 gloves are minimum for 480V work, and the shock protection boundaries must be observed.
NFPA 70E Table 130.7(C)(15)(a)
The incident energy analysis on the arc flash label indicates Category 3 hazard. Wearing Category 1 PPE (4 cal/cm²) provides dangerously insufficient protection for a Category 3 exposure (25 cal/cm²). PPE category must meet or exceed the hazard level.
CraftIQ explanations are original educational commentary written in trade language and verified against the cited standards. Always confirm requirements against the code edition adopted by your jurisdiction — this is training material, not a substitute for the code book or your AHJ.