NEC 645.5(E)(2)(5)

NEC 620.37 / IMC 602.2

NEC 620.37 and IMC 602.2 prohibit using elevator machine rooms as supply, return, or exhaust air plenums for other building spaces. Ductwork from adjacent spaces introduces contaminants, fire risk, and smoke migration paths into the machine room. The machine room must have its own dedicated ventilation system.

NEC 645.10

This satisfies NEC 645.10. Article 645 is an optional set of alternate rules for an IT equipment room, and one of the conditions for using it is a disconnecting means that will remove power from all electronic equipment in the room and shut down the dedicated HVAC serving it, with the controls grouped, identified, and readily accessible at the principal exit doors. The logic is a firefighter's: someone should be able to kill the load and the air moving through it on the way out, without hunting through a dark room full of energized cabinets.

NEC 645.5 / NEC 300.22

This fails code. When the space under a raised floor is used as an air-handling plenum — which is the standard cooling configuration in data centers — NEC 300.22 and NEC 645.5 restrict the types of wiring methods permitted. Standard NM-B cable is not rated for plenum use because its PVC jacket produces toxic smoke and fumes when exposed to fire. Only plenum-rated cables (such as Type DP), wiring enclosed in metal conduit, or other listed wiring methods specifically approved for plenum spaces are permitted. This requirement exists because toxic smoke spread through the air distribution plenum could rapidly contaminate the entire data center and endanger personnel.

NEC 700.10(B)(1)

NEC 700.10(B)(1) requires emergency circuit wiring to be kept entirely independent of all other wiring and equipment. Routing emergency and normal power in the same raceway means a single fire or physical damage event can disable both systems simultaneously, eliminating the redundancy that emergency power provides.

NEC 700.32 / 701.27

NEC requires selective coordination of overcurrent protective devices for emergency systems, legally required standby systems, and critical operations power systems. Without it, a fault on one circuit can trip upstream devices, blacking out the entire system.

NEC 708.22

This fails code. NEC Article 708 (Critical Operations Power Systems) Section 708.22 (Capacity of Power Sources) requires the alternate power source to be sized for a minimum of 72 hours (3 days) of full-load operation of the Designated Critical Operations Area. The 24-hour supply provides only about 33% of the required minimum run time. The 72-hour requirement exists because during major disasters such as hurricanes, earthquakes, or ice storms, fuel delivery infrastructure can be disrupted for days or even weeks. A COPS facility must be capable of sustaining critical operations independently during extended emergencies, regardless of assumptions about local fuel delivery availability. Management convenience or cost considerations do not override this code requirement.